You Have Installed A New Switch With Connected Workstations As Shown In The Diagram

When you are finished use the copy run start command in exec mode to save the changes. You would like to use vlans to create workgroups based on job function.

Computer Network Diagram Wikipedia

By default vlan 1 exists and all ports are members of that vlan.

You have installed a new switch with connected workstations as shown in the diagram. The new servers will be used for virtualization. You are adding a new rack to your data center which will house two new blade servers and a new switch. You do not need to assign membership for these switch ports.

If your pc has a static ip address before you begin you should change your pc settings to temporarily use dhcp. To run express setup. In step 9 a ping from wrk1 to all other workstations fails because the port connecting wrk1 to the switch is now in a different vlan.

You can then access the switch through the ip address for further configuration. You do not need to assign membership for these switch portsn. The only space you have available in the data center is on the opposite side of the room from your existing rack which already houses several servers a switch and a router.

When you are finished use the copy run start command in exec mode to save the changes. Hosts can only communicate with other hosts that are connected to switch ports that are assigned to the same vlan. Your task in this lab is to create the following vlans and assign port membership as follows.

Step 1 verify that no devices are connected to the switch because during express setup the switch acts as a dhcp server. By default vlan 1 exists and all ports are members of that vlan.

Kvm Switch Wikipedia